Set up Mobility Print with a Site Server

NOTE

This is applicable only when Mobility Print is installed together with PaperCut NG/MF. For more details, take a look at this page.

Mobility Print works on a Site Server in online and offline mode if you are running PaperCut 17.1 or higher.

When Mobility Print was installed in PaperCut NG/MF 17.0 but is now running in 17.1 or later

If you have set up Mobility Print with a Site Server using PaperCut NG/MF 17.0, and have since upgraded to PaperCut 17.1 or later, you need to perform the changes described below. The upgrade enables Mobility Print to work with a Site Server when the connection with the Application Server is down.

  1. Open the following file in a text editor:

    [app-path]/data/config/papercut-server.conf

  2. Remove the lines starting with:

    ApplicationServer=

    ApplicationServerPort=

  3. Save the file.

  4. Restart the PaperCut Mobility Print service.

This ensures that PaperCut Mobility Print works in offline mode.

For PaperCut NG/MF 17.0 only

If you are running PaperCut NG/MF 17.0, you need to make the following changes to config files for Mobility Print to work.

NOTE

With this change, Mobility Print will not work if the connection between the Application Server and the Site Server is down. To fix the issue, upgrade the PaperCut NG/MF Application Server and Site Server to 17.1 or higher.

  1. Open the following file in a text editor:

    [app-path]/data/config/papercut-server.conf

  2. Set the following values:

    ApplicationServer=[Application Server IP address]

    ApplicationServerPort=9191

  3. Save the file.

  4. Restart the PaperCut Mobility Print service.